MakerBot Digitizer Bedienungsanleitung PDF herunterladen (Seite 47)

47SCANNING WITH YOUR MAKERBOT DIGITIZER

SCANNING AN OBJECT

Note: Do not touch or move the

object being scanned while the

scan is in progress.

Note: Did you get a mesh that doesn’t look like your object? If some parts of your object

look much better than others, try adding an additional scan using MultiScan Technology.

If the whole scan looks wrong, and you’ve double-checked your lighting, object

placement and calibration, it’s possible that you just have an object that doesn’t scan

well. We’re working on making sure there are fewer of those, and you can help by sending

us some information about your failed scan. See page 58 in the Troubleshooting section

for more details.

During the scan, data points will

appear in the viewport as the MakerBot

Digitizer identiﬁes points on the

surface of your object. A progress

bar will also appear, showing the

estimated time remaining in the scan.

During the scan, you can use your

mouse to view the partial point cloud

from dierent angles.

Aer the MakerBot Digitizer ﬁnishes scanning your object, MakerWare for Digitizer will

automatically turn the generated point cloud into a manifold 3D mesh. A manifold 3D mesh

is completely enclosed and has no holes, reversed faces or extra geometry.

The meshing process should take approximately two minutes. When the mesh is complete,

it will appear in the viewport.

5 Click Start Scan

• To rotate: le-click and drag within the viewport

• To pan: middle-click and drag within the viewport OR shi key + le-click and drag

within the viewport

• To zoom: scrollwheel

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 73 74

Keine Kommentare

MakerBot Digitizer Bedienungsanleitung Seite 47