MakerBot Digitizer Bedienungsanleitung PDF herunterladen (Seite 28)

PLACEMENT OF THE MAKERBOT DIGITIZER

Finding the right location for your MakerBot Digitizer is important.

Follow these guidelines to ensure the best quality scans:

• Set up your MakerBot Digitizer in an indoor area with ample incandescent

or ﬂuorescent light. Avoid natural light sources.

• Avoid pointing the MakerBot Digitizer’s camera and lasers toward light sources.

Avoid placing the MakerBot Digitizer directly below a light source.

• Place your MakerBot Digitizer on a ﬂat, stable work surface and make sure no part of

the MakerBot Digitizer extends over the surface edge. If it is not in a stable position,

the MakerBot Digitizer could fall, damaging itself and causing injury to the user.

• Make sure to set up your Makerbot Digitizer at least one foot away from the nearest wall.

Light sources

should be placed

outside of the

MakerBot Digitizer’s

line of sight.

Avoid natural light

aiming directly at camera.

MAKERBOT DIGITIZER

AERIAL VIEW OF ROOM

Set up at least 1 

away from a wall.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 73 74

Keine Kommentare

MakerBot Digitizer Bedienungsanleitung Seite 28