MakerBot Replicator Z18 Bedienungsanleitung PDF herunterladen (Seite 29)

STARTUP29

FIRST STEPS

CONNECT TO YOUR COMPUTER

There are four ways to move ﬁles from your computer to your MakerBot Replicator Z18:

Wi-Fi, Ethernet, USB cable and USB drive. Before you proceed, set up your computer to

connect using one of these methods.

To connect via Ethernet:

1. Locate an Ethernet cable (not included).

2. Connect one end of the cable to the Ethernet port at the back of your MakerBot Replicator

Z18. Connect the other end to a wall jack or router used by your local area network. MakerBot

Desktop will automatically detect your MakerBot Replicator Z18 during soware setup.

To connect via USB cable:

1. Locate the included USB cable.

2. Insert the USB-B end of the cable into the port on the back of your MakerBot Replicator

Z18 and insert the USB-A end of the cable into a USB port on your computer. MakerBot

Desktop will automatically detect your MakerBot Replicator Z18 during soware setup.

To connect via Wi-Fi:

1. Locate the included USB cable.

2. Insert the USB-B end of the cable into the port on the back of your MakerBot Replicator

Z18 and insert the USB-A end of the cable into a USB port on your computer. MakerBot

Desktop will automatically detect your MakerBot Replicator Z18 during soware setup and

use the USB connection to connect it to your Wi-Fi network.

To transfer ﬁles via USB drive:

No additional setup will be required. See Chapter 4 for instructions on exporting print ﬁles.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 66 67

Keine Kommentare

MakerBot Replicator Z18 Bedienungsanleitung Seite 29