MakerBot Replicator 2x Bedienungsanleitung PDF herunterladen (Seite 72)

TROUBLESHOOTING

DISASSEMBLING AN EXTRUDER

1. Unload the MakerBot Filament from the extruder. To run the script for unloading

ﬁlament, navigate to Utilities > Change Filament > Unload on the LCD panel.

Switch o the power on the MakerBot Replicator 2X and unplug the power supply. Pull

on the connector to release it from the power input port.

3. Unscrew the two bolts at the lower corners of the fan guard using your 2.5 mm hex

wrench. As one piece, remove the fan guard, the fan, the heat sink, and the spacers.

Keep these pieces assembled and move them out of the way.

4. Unplug the motor wire harness from the top of the extruder motor and slide the motor

assembly out of the extruder.

PRINTING ISSUES CONTINUED

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 91 92

Keine Kommentare

MakerBot Replicator 2x Bedienungsanleitung Seite 72