MakerBot Replicator Bedienungsanleitung PDF herunterladen (Seite 14)

GettinG started14

SETTING UP THE MAKERBOT REPLICATOR

Locate and unwrap the Smart Extruder

and press it against the back of the extruder

carriage, with the connector pins facing

the extruder carriage. Magnets will lock

the Smart Extruder into place.

1 INSTALL THE MAKERBOT REPLICATOR SMART EXTRUDER

2a. Locate the MakerBot PLA Filament spool

and remove it from its plastic bag.

2b. Grasp the back section of the frame of

the MakerBot Replicator and pull upwards to

open the ﬁlament drawer. Open the drawer

all the way.

2 INSTALL THE SPOOL OF MAKERBOT PLA FILAMENT

Note: If you need to install the

Smart Extruder again at any time,

go to the control panel and select

Utilities > System Tools > Attach

Smart Extruder.

Caution: Never remove the MakerBot Replicator Smart Extruder from your MakerBot

Replicator during or immediately aer printing. Always allow the Smart Extruder to cool

completely before removing it from the 3D printer.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 60 61

Keine Kommentare

MakerBot Replicator Bedienungsanleitung Seite 14