MakerBot Replicator 2x Betriebsanweisung PDF herunterladen (Seite 32)

REPLACING KAPTON TAPE CONTINUED

LUBRICATING Z-AXIS ROD AND IDLER PULLEY

7. If there are still bubbles under the Kapton

tape, li the edge of the tape that is nearest

to the bubbles and use the tape applicator

to smooth the tape from the center out.

8. When the Kapton tape is applied as

smoothly as possible, trim the edges of

the sheet or fold them over the sides of

the build plate.

NOTE: To view a video of this process, go to the

MakerBot Replicator 2X video page at makerbot.

com/support/replicator2x/videos and select the

video Replicator 2X Kapton Tape Application.

Fig. 2.5

Aer approximately 50 hours of build time,

you should lubricate the threaded rod on your

Z-axis and the X-axis idler pulley.

To lubricate the threaded rod and the idler pulley:

1. Find the tube of PTFE-based grease

included in the package with your the

MakerBot Replicator 2X. If you have used up

this tube of grease, PTFE-based grease is

available from many online retailers.

2. Grasp both sides of the build platform

and push it gently to the bottom of the

MakerBot Replicator 2X.

3. Use a clean, lint-free rag [or your nger]

to spread the PTFE-based grease onto as

much of the threaded rod as you can reach.

Make sure you get the grease inside the

threads themselves. [Fig. 2.5]

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Keine Kommentare

MakerBot Replicator 2x Betriebsanweisung Seite 32