MakerBot Replicator 2x Bedienungsanleitung PDF herunterladen (Seite 14)

Page 13

Rev.2

Figure 11 - Removing A Part

Tool Crashing – This is when the nozzle physically crashes into the build

surface. It can look like plastic is being smeared and the build platform is

being flexed. Additionally, this can rip the Kapton tape.

This is why it is important to properly level the build plate before you print,

because the person before you might have done it incorrectly.

J. Removing Your Part

After your part has finished printing, you can remove it from the build

platform. Since the build platform has been heated, it is important to let the

part cool before removing it. If you remove the part before it cools enough, the

part can become warped or damaged.

DO NOT TOUCH THE BUILD PLATE! EVEN WHEN COOLING IT CAN

REMAIN OVER 100°C – HOT ENOUGH TO BOIL WATER!

Once the part is cool enough, use a plastic putty knife to pry up one of the

edges and follow it down the part.

NEVER USE METAL ON THE KAPTON TAPE!

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

MakerBot Replicator 2x Bedienungsanleitung Seite 14